Extend the Life of your HVAC Equipment

Posted on February 22, 2018 by WestAIR Heating & Cooling

Having a working furnace and air conditioner is crucial during the winter and steamy summer days. Don’t run it and forget about it, as wear and tear is inevitable. You can save on costly replacements or repairs through proper maintenance. Extend the life of your HVAC equipment by following these steps.

Heating & Cooling Tips

1. Follow manufacturer instructions.

2. Have your systems checked every year by a qualified service technician. It’s best to schedule maintenance in the spring and fall. Technicians are busy in the hot and cold months, and you don’t want to wait until there’s something wrong.

3. Check your filters. Replace your filters every 30 to 60 days. If you have a permanent filter, clean it with mild detergent every 30 to 60 days. This is the most important step to increase the life of your equipment. Dirty filters make heating and cooling units work harder, which will shorten the life with use.

4. Keep your doors and windows closed. Your air conditioner and heater will work harder when there is more air to circulate. Make each space with ventilation smaller by closing your doors. This is the also the case for houses with boilers or window air conditioners. Rather than labor to regulate air temperature in the whole house, your a/c only needs to cool the individual room. With a boiler system, it’s efficient to close off rooms without a radiator.

5. Caulk and weather-strip air gaps on windows. This step is good for your wallet and your HVAC equipment. Old houses are especially drafty, so locate the air leaks by finding damaged glazing or old caulking. Another trick is to turn off all appliances and light an incense stick in each room. Turn on your exhaust vent if you have one. Then hold your incense stick close to windows, doors, and walls for a noticeable change in the smoke. If you have drafty doors, invest in some door draft blockers.

6. Use your thermostat. It’s a myth that you should keep your thermostat at a steady temperature. Most of the time, your furnace will be working harder to maintain the heat at a steady rate. Instead, program your thermostat for a comfortable temperature while you are home and ten degrees less while you are away. However, fidgeting with the thermostat will be less efficient, even if it seems harmless to put it up or down a degree or two. Keep it on a consistent schedule.

Energy Efficiency

Winter

1. Open window shades when windows are facing the sun. Let the sun warm your house naturally, putting less work on your furnace. The vitamin D is good for you this time of year!

2. Take advantage of using your oven. Slow cook your chicken and oven roast your veggies. The extra warmth will give your furnace a break. Your oven will be working two jobs at once without the added cost.

Summer

1. Close window shades facing the sun. Opposite of wintertime, you want to block the sun from adding extra heat to your house. Make sure to put your plants outside so they don’t suffer from the lack of sun!

2. Be smart with your other appliances. When you are doing laundry, hang up your clothes on a line to save energy or strain on your a/c. Why work an appliance that uses heat when it’s already hot outdoors? Washing clothing shouldn’t be an issue, though, if you stick to cold water. If it’s humid out, dry your clothes during the coolest part of the day: around dawn. Same goes for dishwashers.

3. Use your exhaust fans when cooking. Whether you plan on using the oven or stovetop for dinner, turn on the exhaust fan to let out the excess moisture and heat. Or maybe fix a cold sandwich or salad. In return, your air conditioner won’t have to work as hard! Same goes for your bathroom, but not everyone likes cold showers!

Annual Service Maintenance

Spring is around the corner, so it’s time to schedule your maintenance visit with WestAir Heating & Cooling.
Our technician’s maintenance list will take care of most things you cannot do yourself to ensure your equipment is running smoothly for summer and winter:

Annual Service Maintenance list:

• Clean furnace and check operation/filter
• Clean air conditioner and check operation
• Clean outdoor condenser and check refrigerant level
• Clean air exchanger filters and core
• Check radiant in-floor pressures and go over system
• Check humidifier filter and drain line
• Check unit heater operation
• Clean fireplace and check operation

Contact us for more information on heating, cooling, or our service maintenance!

This entry was posted in AC,Air Conditioning,Cooling,Furnace,Heating,Winter and tagged A/C, A/C, Air conditioner, Air filters, Air quality, Annual check-up, Caulk, Clogged filter, Cold air, Cooking, Cooling, Cost, Dirty, Dishwasher, Door draft stopper, Doors, Drafty windows, Dryer, Efficiency, Energy efficient, Exhaust fan, Fall, Filter, Filters, Furnace, Furnace filter, Heater, Heating, HVAC, Laundry, Maintenance, Quality, Save money, Shower, Spring, Summer, Sunshine, Sustainability, Thermostat, Windows, Winter

Why You Should Change Your Furnace Filter Often

Posted on January 22, 2018 by WestAIR Heating & Cooling

Changing your furnace filter seems to be an easily forgotten task. HVAC companies try their hardest to remind you to do these things, but do you know why you should change it more often than you think?

Maintenance

Getting an oil change for your car is as important as changing the furnace filter for your house. It simply extends the life of your equipment. A dirty filter means that less air is circulating, which then means that your furnace is working harder to keep your house warm. Over time, having a furnace go into overdrive for too long can overheat the system or break down the entire unit. This is not something you do want to deal with in subzero temperatures.

A little dirt can do a lot of damage. If your furnace filter is dirty, not only will it make your HVAC unit work harder, but it will also make your heating bills go up over time. All the extra effort that this heater is putting out digs a deeper hole into your wallet. While a new furnace filter might cost money, ignoring it will cost more in your gas bill, except you’re doing more damage than good by trying to be frugal.

Air Filter Quality

Skip the fancy furnace filters. A furnace filter is designed to protect your furnace, not improve indoor air quality. Some people swear by these special filters, but you’ll most likely have to run your furnace fan year-round to get the benefit of a high-efficiency filter. Extra work and extra care (replacing them often) will cost you more in the end.

There is a happy balance that you could achieve between cost and efficiency. For homeowners, we recommend purchasing a MERV 7 or 8 pleated filter, which traps 80 to 95 percent of air particles. If you are looking to get rid of pollutants and breathe cleaner air, consider getting an air cleaner instead.

When to call your HVAC technician

– Unit fails to turn back on
– Noisy or slow fan
– Bent fins
– Coils are extra dusty

Remember to change your furnace filter every month when fan is in use for heating and cooling seasons.
Got more furnace questions? Call us at (763) 498-8071.

This entry was posted in AC,Air Conditioning,Cooling,Energy Savings,Furnace,Heating,Indoor Air Quality,Tips and tagged Air filters, Air quality, Clogged filter, Cold air, Cost, Dirty, Efficiency, Filter, Filters, Furnace, Furnace filter, Heater, Heating, HVAC, Maintenance, Quality, Save money, Winter

Six Tips to Reduce Your Heating Bill

Posted on November 29, 2017 by WestAIR Heating & Cooling

Winter has arrived in full force, but that doesn’t mean you have to blast money from your wallet as you turn up the heat. WestAIR Heating and Cooling offers six easy ways to reduce your heating bill this winter and for years to come.

1. Control your Thermostat

Using a thermostat is an easy way to control your home temperature and maximize your savings. While you are away, set it 10 degrees cooler than your regular setting. So, if you feel comfortable at 69 degrees, you would program it to be 59 degrees while you’re at work or on vacation. Some newer thermostats have capabilities to be controlled by a phone app or website!

2. Insulate Windows and Walls

You can lose half of your heat if your home is not well insulated! Is your attic or basement insulated? If not, fill all the gaps with fiberglass insulation. If your windows are drafty, fill in the leaky spaces with caulk.

3. Look at those Ducts

Heat can leak right through your air ducts too. You can patch them with aluminum foil tape (not duct tape) and mastic sealant. First, clean the surface near any leak you find in your air ducts. The aluminum foil tape works best on flat surfaces. Mastic is for curved surfaces that would be difficult to tape. Use both for leaks bigger than a quarter-inch for extra protection!

4. Keep Up on Filters

Did you know that you should change your furnace filter each month? Not only will it let warm air flow freely, but it will reduce the need for costly repairs. Inexpensive fiber filters work fine, but standard pleated filters are better for airborne dust.

5. Take Care of your Furnace

Many people forget this step, but tune-ups are necessary for furnaces just like an oil change is for your car. Nobody wants to wake up shivering in the middle of the night because the furnace isn’t working properly. Although we do offer same-day and emergency service in case this happens, avoid breakdowns with a scheduled maintenance check. Take advantage of our current promotion and save $10 on any repair or service call.

6. Invest!

Sometimes you must kick your old furnace to the curb. If your repair costs more than 50 percent of the cost of a new furnace, or your monthly heating bills have significantly increased, you should most likely consider a replacement. Upfront costs may seem daunting, but today’s furnaces are more energy efficient and will save money in the long run. If you think it’s time to replace that old furnace of yours, we stand by Rheem heaters for quality. Rheem is a leading provider of top-quality, innovative heating products that offer the latest technology, lasting performance, great warranties, and excellent service and support. As a proud Rheem Pro Partner, our highly trained, licensed technicians can recommend a Rheem furnace or other heating product to best meet your needs.

Contact us to learn more about a furnace tune-up or questions!

This entry was posted in Energy Savings,Furnace,Heating,Tips and tagged Advice, Cold, Cold weather, Ducts, Efficiency, Filters, Furnace, Heat, Heater, Heating, HVAC, Insulation, Minnesota, Reduce costs, Repair, Rheem, Save money, Thermostat, Tips, Weather, WestAIR, Winter, Winterize